Advertisement
Quick Links
Product Family
MQT (previously Type RS)
Unit Size
06 = Nominal 6,000 Btuh cooling
09 = Nominal 9,000 Btuh cooling
11 = Nominal 11,000 Btuh cooling
14 = Nominal 14,000 Btuh cooling
Vintage Designation
B (Sizes 06, 09, 11)
C (Size 14)
Unit Type
A = Air conditioner with electric heat
B = Air conditioner with hydronic heat
C = Heat pump with supplemental electric heat
®
MQT (Type RS)
Incremental
Model Nomenclature
MQT
®
Heat Pump
09
B
C
5
B
Installation and
Maintenance Data
Bulletin No. IM 354-4
June 1995
Form No. 802048241
Heater Code
A = 2.0 kW electric heat
B = 3.2 kW electric heat
C = 4.8 kW electric heat
G = Steam heat
W = Hot water heat
Voltage
3 = 230/60/1
5 = 208/60/1
7 = 265/60/1
©1995 McQuay International
IM 354 / Page 1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for McQuay Incremental MQT Series
Summary of Contents for McQuay Incremental MQT Series
- Page 1 B (Sizes 06, 09, 11) C (Size 14) Unit Type A = Air conditioner with electric heat B = Air conditioner with hydronic heat C = Heat pump with supplemental electric heat ©1995 McQuay International IM 354 / Page 1...
-
Page 2: Conditioner Description
Caution: Sharp edges and coil surfaces are a potential injury hazard. Conditioner Description The McQuay MQT heat pump is designed and built for 2. Louver Frame — Optional; shipped in separate carton. through-the-wall installation in either new or existing build- 3. - Page 3 b. Conditioner with Subbase — Where the optional Figure 3. Conditioner — with subbase subbase is used, the rectangular knockout in the right front bottom of the wall sleeve is removed to allow the subbase junction box to be mounted directly beneath the wall sleeve (see Figure 3).
- Page 4 Subbase Installation: 5. Complete the electrical work in the subbase and the 1. The subbase provides a 1 ⁄ " (30mm) inset on the sides of junction box. the conditioner. Locate the subbase on the floor and align its center line with the center line of the wall opening (see 6.
- Page 5 Figure 7. Panel and Thin Wall Application 1. Install the subbase as described in the subbase installa- tion section. 2" (51mm) 2. Install the louver frame as described in the louver frame installation section. 2" 3. Position the room cabinet/wall sleeve in the louver frame (51mm) opening and on the subbase.
-
Page 6: Louver Installation
Louver Installation Install the outdoor louver from inside the room. Hold the louver pull it back to the wall sleeve rear face so that the louver studs with a wire loop or other similar means. Push the louver out pass through the holes in the wall sleeve flanges. Securely through the rear opening of the room cabinet/wall sleeve and tighten the louver in place using the washers and nuts provided. - Page 7 Note that handling, causing fans to strike. The correction of such unless otherwise specifically agreed to in writing, McQuay conditions is part of the start-up. IM 354 / Page 7...
- Page 8 Installation, Service & Warranty Policy One-Year Warranty of Entire Conditioner— McQuay Inter- of refrigeration circuits not readily separable therefrom are national, hereinafter referred to as the “Company,” warrants warranted to the original owner for one year.
Need help?
Do you have a question about the Incremental MQT Series and is the answer not in the manual?
Questions and answers