Inateck P7 User Manual page 7

3. Enable the Bluetooth of the device to be connected, e.g. PC, cellphone or tablet. You can
do that like below.
Windows XP: Click Control Panel->Printers and Other Hardware->Add Bluetooth Device
Windows 7/8/8.1: Click Control Panel->Add Devices
Windows 10: Click Setting->Devices->Bluetooth
macOS: Click System Preference->Bluetooth
iOS: Click Setting->Bluetooth
android: Clik Setting->Bluetooth
Enable the Bluetooth on host device and it will automatically search for P7. After a few
seconds 'P7******' will appear in the list of available devices. Pair the two devices. A
chords sound means successful pairing.
4. Open a file on computer and move cursor to the blank where scanning output should
be placed. Scanning results can be displayed on computer then.
Note:
1) Normally P7 can re-connect to previously connected device automatically. If it fails,
please remove the paring history of P7 in the list of host device. Afterwards, pair them
again.
2) HID and SPP are two modes of Bluetooth. The pairing method mentioned above refers
to HID, which is the most commonly used mode. If you want to use P7 under SPP mode,
please visit www.inateck.com to download complete instruction manual for setting, or
contact support@inateck.com.
Wired Mode:
1. Connect Inateck P7 with computer via USB cable
2. Power on Inateck P7 by toggling switch from OFF to ON and short press the trigger.
Inateck P7 will continuously beep. Beep stops after successful connection.
3. Open a file on computer and move cursor to the blank where scanning output should
be placed. Scanning results can be displayed on computer then.
EN
5