Yamaha PortaTone PSR-7000 Owner's Manual page 82

Custom Accompaniment
<
Record the Selected part
You can now add new notes to the selected part
by playing the keyboard at the appropriate timing.
All parts must be entered in the key of C major 7. If
both the
metronome will sound to provide a timing guide (the
metronome sound is not recorded). A single drum
instrument can be cleared from the
track by pressing the key corresponding to
the instrument to be cleared while holding the
NOTES
• Key On/Off ,Voice , Volume , Pitch Bend and Modulation
data can be recorded.
• When the RHY1 or RHY2 part is selected the keyboard
percussion mode is automatically engaged. In this case
the drum kit voice can be changed via the RIGHT 1 voice
selectors. All voices in the [CUSTOM] group can be
selected — but only drum kit voices will sound.
• If a preset style or an SFF style loaded from disk is being
used unedited, or a part contains no data, REC will appear
in gray for all except the RHYTHM parts and the REC
mode cannot be selected. New data can be recorded for
such parts by first deleting all data from the part.
• Playback can be started and stopped via the [START/
STOP] button as required while in the CUSTOM ACCOMP.
RECORD mode — data cannot be recorded while play-
back is stopped. It is a good idea, however, to use
[SYNCHRO START] if you want to record from the top of
the first measure.
>
Repeat Until All Parts Have Been Recorded
Continue selecting the
tracks and recording them as required until all parts
have been recorded.
?
Set the Part Volume Levels
Use the LCD button to the left of the display
to select the
of each part to create the best overall balance. Since
these are "offset" parameters, both "+" and "–"
settings are possible to increase or decrease the
volume from the preset level, respectively. These
settings apply to the corresponding parts in all
sections of the accompaniment.
78
....................................................................................................................................................
and parts are cleared the
LCD button.
mode for the various
...............................................................................................................................................
parameters. Then use the
LCD dials to adjust the volume
and/or
• The volume of the voice being edited can be adjusted by
pressing the [MIXER] button and using the R1 LCD dials.
• A "KEY OFF" event will automatically be recorded after the last
note in the accompaniment.
• If a custom accompaniment which includes an empty section is
saved to disk, the empty section will be replaced by a suitable
section when the accompaniment is later loaded and played.
..................................................................................................