Table of Contents
Advertisement
Eco wash
This programme is intended for cleaning normally dirty dishes and
is the most effective programme in terms of combined energy
and water consumption.
The High temperature option must be selected to access the
programme used to compile the information for energy labelling.
Rinse & Dry
This programme comprises a rinse with heating and drying. This
is a suitable programme if, for example, you plan to make jam and
want to rinse and heat clean glass jars.
Rinse & Hold
Used to rinse dishes while you wait for the dishwasher to become
fully loaded.
SELECTING OPTIONS
To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected programme. Once you have
started the programme, the options you selected are saved for
the next time you use the same programme. An exception is the
Delayed start option.
High temperature
Activate this option for improved dishwashing results. The machine
then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Heavy wash:
55 °C / 70 °C
Normal wash:
60 °C / 65 °C
Daily wash:
60 °C / 65 °C
Quick wash:
30 °C / 60 °C
Super quick wash:
30 °C / 60 °C
Delicate wash:
40 °C / 50 °C
Eco wash:
50 °C / 60 °C
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programmes except Rinse & Dry and Rinse & Hold.
If you want a programme with Short dry, press again so that the
field under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at a
time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the
programme.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last programme run.
TIME REMAINING
Once you have selected a programme and options, the display
indicates how long the programme took the last time it was used.
The remaining time is updated after the water for the final rinse
has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
NOTE!
During the first run of each programme, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the programme a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the programme.
STOPPING OR CHANGING A PROGRAMME
If you want to change programme after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new programme, press Start/Stop and
close the door.
(the door
9
Advertisement
Table of Contents
