Table of Contents
Advertisement
Resetting the Pocket Controller
When rebooting cannot be performed or the Pocket
Controller does not work correctly even after rebooting,
follow the procedure below.
1 Turn the Disklavier off.
(→ pg. 6 "Turning the Disklavier Off (Standby
Mode)" in "Quick Guide")
2 Connect the AC adapter to the AC adaptor jack, and
then set the battery replacement switch to the
[REPLACE BATTERY] position.
3 Wait for five seconds, remove the battery
compartment lid, and then press the [RESET] button
with the stylus pen.
4 Replace the battery compartment lid, and then set the
battery replacement switch back to the [NORMAL
OPERATION] position.
5 Press
to turn the Pocket Controller on.
The [Main] screen appears after approximately two
minutes.
NORMAL OPERATION
REPLACE BATTERY
RESET
Pairing the Pocket Controller and the
Disklavier
For normal use, this setup is not required.
1 Make sure that other wireless equipment is turned off.
2 Tap on
[Piano Assign] in the [PRC-100 Menu]
screen.
3 Move the Pocket Controller close to the Disklavier,
and then tap on
.
ESS-ID number
4 Tap on
.
5 Tap on
on the [Assigned successfully] screen.
The [PRC-100 Menu] screen resumes.
Note:
Do NOT abort the procedure before step 4.
Otherwise you cannot control the Disklavier.
CHAPTER 1: Getting Started
Continue to next page...
18
Advertisement
Table of Contents
