Table of Contents
Advertisement
3
Tap on [SplitPoint], and then press
to select a note as the split point
(within the range from [A-1] to [C7]) if
necessary.
The selected note and notes lower than that note are
assigned to the left-hand part, and the notes higher
than that are assigned to the right-hand part.
Note:
The split point can be set only when
both
and
(blue).
4
Tap on the voice name of the desired
part.
5
Tap on the desired voice.
6
Tap on [Volume]
adjust the volume of the selected
voice.
7
Tap on
to complete the
operation.
To mute the piano sound, tap on
turns to red. Each time you tap on
turns on and off alternately.
/
are turned on
/
to
.
, the piano sound
CHAPTER 3: Piano Playing Features
Adding Expressive Effect to
Your Play
In Quiet or Headphone mode, when a voice contained in
[AEM Brass], [AEM Sax], or [AEM Section] Instrument
Group is selected, depressing the pedal adds articulations
specific to the wood/brass wind. Three types of
articulation are assigned to the respective pedals.
Soft pedal:
Assigned for adding Head (blow-up) articulation to
the manner of beginning a note.
Sostenuto pedal:
Assigned for adding Joint articulation to the interval
of two notes.
Damper pedal:
Assigned for adding Tail (fall-down) articulation to
the manner of ending a note.
Soft pedal
Sostenuto
pedal
1
Select the desired voice contained in
[AEM Brass], [AEM Sax], or [AEM
Section] Instrument Group. (→ pg. 69
"Piano Voice List" and pg. 19
"Selecting the Voice in Quiet/
Headphone Mode" in "Quick Guide")
2
Operate the key and the desired
pedal.
The key and pedal operation varies depending on
the type of the articulation.
For Head (blow-up) articulation
1 Press and hold the soft pedal, and then press the
desired key.
The blow-up speed is controlled in accordance
with the angle of the pedal that is pressed.
Damper pedal
Continue to next page...
40
Advertisement
Table of Contents
