Specifications; General Specifications - Yamaha power mix EMX 2000 Owner's Manual

Specifications
General specifications
Maximum output power
Frequency response
Total harmonic distortion
Hum & noise
(Average, Rs=150 )
(with 20 Hz~20 kHz BPF)
Maximum voltage gain
Crosstalk at 1 kHz
MIC IN gain control
Input channel equalization
Meters
CH peak indicators
Limiter
LIMIT indicators
Graphic equalizer
Internal digital effect
Foot switch
Phantom power
Option
Power requirement
Power consumption
Dimensions (WxHxD)
Weight
STEREO: 200 W+200 W/4 @0.5% THD at 1 kHz
BRIDGE: 400 W/8 @0.5% THD at 1 kHz
20 Hz~20 kHz +1 dB, –3 dB
@1 W output into 8
(SPEAKER OUT)
20 Hz~20 kHz +1 dB, –3 dB
@+4 dB output into 600
(ST OUT, MONO OUT, EFFECT
SEND, MONITOR OUT)
Less than 0.5% @20 Hz~20 kHz, 100 W output into 4 (SPEAKER OUT)
Less than 0.3% @20 Hz~20 kHz, +14 dB output into 600
(ST OUT, MONO OUT, EFFECT SEND, MONITOR OUT)
–128 dB equivalent input noise
–63 dB residual output noise (SPEAKER OUT)
–95 dB residual output noise (ST OUT, MONO OUT, EFFECT SEND, MONITOR OUT)
–87 dB
(ST OUT, MONO OUT)
–64 dB (68 dB S/N)
(ST OUT, MONO OUT)
–80 dB
(EFFECT SEND, MONITOR OUT)
91 dB MIC IN to SPEAKER OUT (CH 1~8)
64 dB MIC IN to ST OUT
38 dB LINE IN to ST OUT
38 dB ST IN to ST OUT
70 dB MIC IN to EFFECT SEND (CH 1~8)
64 dB MIC IN to MONITOR OUT (CH 1~8)
–70 dB adjacent input, –70 dB input to output
44 dB variable
HIGH 10 kHz shelving*
MID 2.5 kHz peaking
LOW 100 Hz shelving*
* Turn over/roll off frequency of shelving: 3 dB below maximum variable level.
13 points LED meter
Red LED on each channel lits when POST EQ signal reaches the level –3 dB below clipping.
Comp. : THD 0.5%
Lit when THD 0.5%
7 bands (125, 250, 500, 1k, 2k, 4k, 8k Hz), 12 dB Maximum
16 programs
Digital effect mute: on/off
+48 V is supplied to electrically balanced inputs.
FC5
USA and Canada 120 V AC 60 Hz
Europe 240 V AC 50 Hz
Other 230 V AC 50 Hz
210 W
480 125 454 mm
14 kg
All channel Gain controls at minimum.
All channel Gain controls at minimum.
ST master/MONO master fader at maximum level and all
channel fader at minimum.
ST master/MONO master fader and 1 channel fader at maxi-
mum level. And 1 channel Gain control at maximum.
Master fader at maximum level and all channel level controls
at minimum.
(CH 1~8)
(CH 1~8)
(CH 9/10, 11/12)
17
EMX2000—Owner's Manual