Rear Panel - Yamaha power mix EMX 2000 Owner's Manual

Rear panel

R
2 1
1
SPEAKERS (speaker output) jacks
Speakers can be connected to these jacks.
The type of signals output, the number of speak-
ers you can connect, and acceptable impedance
differ depending on the setting of the Power amp
select switch (control panel V).
• When the Power amp select switch is set to ST
L-ST R or MONI 1-MONO:
You can connect one or two speakers to each of
the L and R jacks.
When the Power amp select switch is set to ST L-
ST R, the speakers connected to the L and R jacks
will output the ST L and ST R bus signals. When
the switch is set to MONI 1-MONO, the speakers
will output the MONITOR L signal and the mon-
aural signal respectively.
Whichever way the switch is set to, connect 4~8
speakers if you use one speaker per channel. The
maximum output is 200W+200W with two 4
speakers.
If you wish to use two speakers per channel, use
8~16 speakers. The maximum output is
200W+200W with 8 impedance.
• When the Power amp select switch is set to
MONO BRIDGE:
If you are connecting a single speaker to the
BRIDGE jack, use a 8~16 speaker. The speaker
outputs the MONO bus signal, and the maxi-
mum output is 400W with 8 impedance.
If the signal output from the BRIDGE jack is the
signal input to the P.AMP IN jack, be sure to
input the signal to the P.AMP IN L jack.
1
SPEAKERS
L
BRIDGE 2 1
POWER
ON OFF
2
Caution:
When using a bridge connection, do not con-
nect anything to the SPEAKERS L or SPEAK-
ERS R jacks.
Likewise, when using the SPEAKERS L and/
or SPEAKERS R jacks, do not connect any-
thing to the BRIDGE jack.
2
POWER switch
This switch turns on/off the power to the
EMX2000.
Note: Before turning on the power to the
EMX2000, be sure to turn down the LEVEL
control U on the control panel.
11
EMX2000—Owner's Manual