Panasonic KX-TGP600G Operating Instructions Manual page 171

Problem
Noise is frequently
heard.
Two short beeps are
heard during a
conversation.
The charge indicator
flashes red rapidly.
You charged the
batteries for 6
hours, but the beep
tones sound, and
(needs to be
charged) flashes
after a few
telephone calls.
While charging the
battery, the handset
and the AC adaptor
feel warm.
"No Service" is
displayed, and beep
tones are heard.
While charging the
battery, the LED
indicator blinks
rapidly, but the
handset does not
beep.
Possible Cause
Nearby electrical
appliances are causing
interference, or you are
too far from the base unit.
The radio signal is weak.
The charger is not
connected properly.
The battery charge
contacts may be dirty.
It is time to change the
batteries.
These are normal
conditions.
The handset/desk phone
is out of range.
The base unit or Server is
out of service.
The temperature of the
battery being charged is
outside of normal limits.
10.1.8 Troubleshooting
Solution
• Place the handset/desk
phone and base unit away
from other electrical
appliances.
• Move closer to the base
unit.
Move closer to the base unit.
• Make sure the battery is
inserted properly.
• Set the handset in the
charger properly.
• Contact your phone
system dealer/service
provider.
Clean the battery charge
contacts without damaging
them and charge once more.
Replace with a new one.
—
Move closer to the base unit
or try again later.
Contact your phone system
dealer/ service provider.
Confirm that the area where
the handset is being
charged is between 5 ℃
(41 ℉) and 40 ℃ (104 ℉),
and wait for the battery's
temperature to drop.
171