Assembly Instructions - Yamaha Electone EL-100 Owner's Manual

YAMAHA Electone
EL-100 ASSEMBLY INSTRUCTIONS
Carefully read these instructions BEFORE assembling the Electone.
■ Precautions
Be careful not to confuse parts, and be sure to install all parts in the correct direction by following the procedures given
below.
Be sure to assemble the Electone with two or more people.
Don't use the screws other than the ones specified and included in this package. Use of incorrect screws can cause
damage and malfunction.
Be sure to tighten up all screws upon completing assembly.
To disassemble, reverse the procedures.
You need a Phillips (+) screwdriver to assemble the Electone.
1.
Open the package, take out two cardboard pads from the both sides of the package, and place the main unit on
top of the cardboard pads.
Position the pads not to directly contact the terminals equipped on the bottom of the main unit.
2.
Take out all parts from the package.
Please confirm that all parts shown in the illustration are provided.
Dust Cover
Sideboard
(Left)
Sideboard
Grill Net
(Attached to the Speaker Unit)
(Right)
Music
Stand
1
2
Main Unit
3
Speaker
Unit
Pedalboard Cord Cramps: 2pcs.
Screw caps: 4pcs.
Bench
Legs: 4pcs.
Pedalboard Unit
AC Power Cord
Long/Black Screws (ø6X25mm): 4pcs.
Long/Yellow Screws (ø5X25mm): 4pcs.
Short/Black Screws (ø5X12mm): 8pcs.
Bench Board
11
125