Starting Playback From A Specified Point (Search) - Yamaha Disklavier DGC1B Basic Operation Manual

Starting Playback from
a Specified Point
(Search)
Playback can be started from a specified point in a
song. Instead of using fast forward or preview,
you can use this function to go directly to a
desired point within a song.
If the current song uses the minutes and seconds
time format, you specify the point in minutes and
seconds. If it uses the measures and beats time
format, you specify the point in measures and
beats.
Once a time value has been entered, it is saved
until the disk is ejected or the Disklavier is turned
off. If you want to search for the same point
again, just press the search button again.
1
Press [SEARCH].
SEARCH
Remote Control
The time counter on the display flashes.
2
Enter the time that you want to
search for.
For example, to search for 2:56, first press
[2], then [5], then [6].
1 2
4 5
7 8
Remote Control
32
Flashes
SEARCH
3
DRIVE
6
9 0
If the time value is less than 10, that is,
between 00:01 and 09:59, remember to
press [0] first to set the first digit to zero.
If you enter a value higher than the entire
song time, the search goes to the end of the
song.
3
Press [SEARCH] again to begin the
search.
SEARCH
Remote Control
If the Disklavier was already playing when
you pressed [SEARCH], playback will
continue from the new point when the
search is complete. If the Disklavier was
not playing, Pause mode is engaged when
the search is complete.
To search for a new point, repeat step 2.