Skil TS6307-00 Owner's Manual page 20

5. Slide the riving knife up to its highest position so that it is directly over the center of the
blade (Fig. 10).
6. Align and engage the lowest hole in riving knife with the pin, then lock the release lever by
rotating it counterclockwise. Push/pull on the riving knife to verify that it is locked in place
(Fig. 10).
7. Replace the table insert (Fig.11), see "Removing and Installing The Table Insert ").
Fig. 10
Attaching the main barrier guard
WARNING
slide the riving knife to its highest position.
Otherwise, the main barrier guard will not be
positioned rightly in place and could increase the
risk of serious personal injury.
1. With one hand, hold the front of the main
barrier guard by the mounting fork. With the
other hand, lift the guard-release lever up
(Fig. 12).
2. Lower the rear of the main barrier guard and
completely slide the cross bar into the middle
notch on top of the riving knife
(Fig. 12).
20
1
2
Before attaching the main
barrier guard, make sure to
Fig. 11
Fig. 12
Mounting Fork
Guard
Barriers
Cross Bar
Middle Notch
Guard-Release Lever