Skil TS6307-00 Owner's Manual page 14

1 . Power Switch
Switch incorporates a hole for use with a
padlock to prevent accidental starting.
2 . Elevation Wheel
Elevates or lowers the blade. Also used to
tilt the blade -2° to 47 °. The cutting capacity
at 0° is 3-1/2". The cutting capacity at 45° is
2-1/2".
3 . Blade-bevel-lock Lever
Locks the blade to desired bevel angle.
4 . Blade-bevel Scale
Shows the degree to which the blade is tilted.
Total range of the bevel is -2° to 47°.
5 . Base
Supports the table
carry handle.
6 . Push Stick & Storage
Allows you to rip smaller pieces of stock with
a greater level of safety.
7 . Rail-driving Wheel Knob
Drives the rail to move it from side to side.
8 . Rail-lock Lever
Allows you to lock the fence at desired
distances.
9 . Work Support/Auxiliary Fence
Provides support for wider workpieces when
extending the fence beyond the table and for
thinner workpiece with thickness not more
than 3/4" when not extending the fence.
10 . Rip Fence
Provides an auxiliary support (in the lower
position) and over-the-table support (upper
position). Securely attaches to rails in 3
positions with lock latches on both ends.
11 . Rip-fence Scale
Shows the distance from the blade to the rip
fence 14 inches to left, 25.5 inches to right.
12 . Smart Guard System
Consists of three key elements: Riving
Knife (Spreader), Anti-Kickback Device, and
Main Barrier Guard. All of these are part
of a modular system that requires no tools
to assemble or disassemble. This Guard
System must always be in place and working
properly for all through sawing cuts.
13 . Table Insert
Removable for removing or installing a blade
or other cutting tools.
14
saw. Includes integrated
14 . Miter Gauge
Head can be locked in the desired position
for crosscutting or mitering by tightening the
lock knob. ALWAYS SECURELY LOCK THE
HEAD WHEN IN USE.
15 . Table
Provides large working
the workpiece.
16 . Cord Wrap&Storage
Allows you to easily secure the cord so it's
out of the way when transporting or storing.
17 . Miter Gauge Storage
Storage location for the miter gauge when
not in use, or when transporting or storing
the table saw.
18 . Rip-fence Storage
Storage location for the rip fence when
transporting or storing the table saw.
19 . Dust-Chute Elbow & Storage
Storage location for the dust-chute elbow
when not in use, or when transporting or
storing the table saw.
20 . Anti-Kickback Device Storage
Storage location for the anti-kickback device
when not in use, or when transporting or
storing the table saw.
21 . Dust Port/Vacuum Hook-Up
Removable to clear any large pieces of wood
trapped inside. Always check to ensure that
the dust port is securely fastened to the table
saw before use. Attach a 2-1/2" vacuum hose
into the dust port for convenient sawdust
removal.
22 . Stand
Allows table saw to be raised during use.
23 . Main-barrier-guard Storage
Storage location for the Main Barrier Guard
when not in use, or when transporting or
storing the table saw.
24 . Wrench & Storage
Wrench for the removal and installation of
saw blades.
25 . Carrying Handle
Allows you to carry the table saw with one
hand when it is not in use.
surface to support