Skil TS6307-00 Owner's Manual page 16

Remove Cable Tie and Foam
Block
(Used for shipping purpose only)
With the table surface on the ground, locate
the cable tie that anchors the motor/blade
assembly to the base. Using scissors or wire
cutters, cut and remove the cable tie.
the blade bevel lock lever, tilt the blade to 45
degrees, then remove the foam block located
between the motor housing and the table.
(Fig.3)
NOTE: The foam block must be removed
before the blade is raised to avoid possible
damage to the blade.
16
Fig. 3
Release
Remove Styrofoam
Block