Other Song Recording Functions; Track Mix - Yamaha Clavinova CVP-59S Owner's Manual

• Track Mix, Track Delete, Track Quantize, Initial Edit, and Rename functions,
described below, cannot be used when no disk is in the disk drive.

Track Mix

The TRACK MIX function combines the data from two specified tracks and places the result in a third
specified track. The TRACK MIX function is accessed via the RECORD [TRACK MIX] display
(RECORD display page 4).
Z
Specify the Tracks to be Mixed
Use the TRK A and TRK B LCD buttons — or the data dial or [+]/[–]
buttons once the TRK A or TRK B parameter has been selected — to
specify the tracks you want to mix. The initial voices used for the A and
B tracks are shown along with the track number.
X
Specify the Destination Track
Use the TRK C LCD button — or the data dial or [+]/[–] buttons once
the TRK C parameter has been selected — to specify the track you want
the mixed data to be placed in. Any previous data in the destination track
(TRK C) will be erased.
C
Execute the Track Mix Operation
Press the MIX LCD button to begin execution of the track mix op-
eration. The "Are you sure?" confirmation prompt will appear. Press
YES to mix the specified tracks or NO to cancel the operation.
When this is done the MIX LCD button will change to UNDO, al-
lowing you to undo the track mix operation and return to the pre-mixed
data before selecting a different track or exiting from the Track Mix
mode.
Press the [EXIT] button, or the [RECORD] button so that its indica-
tor goes out to exit from the Track Mix function.

Other Song Recording Functions

..........................................................
.............................................................
....................................................
Song Recording
• Only the data-containing tracks will
appear and can be selected for TRK A
and B. In addition "no track" ("- -") can
also be selected for TRK B. — In this
case the result will be the copy of TRK
A to TRK C.
• The initial data and all data other than
note data is taken from that of track A.
• A bar graph indicating the progress of
the track mix operation will appear
while the data is being processed.
• You can check if the results are as you
expected or not, by starting and stop-
ping playback by using the [START/
STOP] button before the UNDO opera-
tion.
83