Dual-Mode Voice Balance; Detune Depth - Yamaha Clavinova CVP-59S Owner's Manual

Dual Mode
The DUAL mode pop-up display can be recalled at any time in order
to change the 2nd voice or other settings (see below) by pressing a
VOICE selector (either the current voice or another voice to select the
2nd voice) while holding the [DUAL] button.

Dual-mode Voice Balance

The volume balance between the two voices combined in the DUAL
mode can be adjusted by pressing the BAL (balance) LCD button to
highlight the BAL section of the display, and then by using the data dial
and [+]/[–] buttons. The BAL LCD button can be held to increase the
level of the 2nd voice only. The balance bar in the BAL section of the
display graphically shows the volume balance between the main (1st)
and 2nd voices. Equal balance can be instantly recalled by pressing the
[+] and [–] buttons simultaneously while the BAL parameter is selected.

Detune Depth

In many cases an even "thicker" sound can be produced by slightly
detuning the dual-mode main and 2nd voices. The DETUNE DEPTH
LCD buttons can be used to set the detune depth value between 0 and 10.
The data dial and [+]/[–] can also be used once the DETUNE DEPTH
parameter is selected. The higher the value the greater the amount of
detuning. The "normal" setting of "5" can be instantly recalled by press-
ing both the DETUNE DEPTH LCD buttons simultaneously.
The DUAL mode can be turned off by pressing the [DUAL] button so
that its indicator goes out.
18
– +
• The dual and split modes cannot be
used at the same time.
• The OCTAVE SHIFT function — page
91 — can be used to shift the pitch of
the main and/or 2nd voice in the DUAL
mode up or down one octave.
• The DUAL mode balance and depth
settings affect all voice combinations.
• The DUAL mode settings are retained
even if the DUAL mode is turned off
and on while the power remains on.
The DUAL mode settings can also be
backed up even after the power is
turned off via the "Backup" function —
page 107.