Yamaha Clavinova CLP-175 Owner's Manual page 115

2.
Attach two front legs and a rear leg.
Refer to the diagram below to verify the orientation of
the legs.
Front leg
Install and tighten four screws on each leg, starting
with one of the front legs.
3.
Install the pedal box.
1 Remove the twist tie that affixes the pedal
cord to the upper portion of the pedal box.
2 Align the cord with the groove on the unit,
and attach the pedal box using four screws.
Rear leg
Front leg
Twist tie
Keyboard Stand Assembly
3 Insert the pedal cord plug into the pedal
connector. Insert the plug so the arrow side
faces front (toward the keyboard).
If the plug will not go in easily, do not
force it. Double-check the orientation of
the plug, then try again.
4 Attach the cord holder on the unit as shown
in the illustration below, then use the cord
holder to affix the pedal cord.
3
4.
Raising the unit to the standing posi-
tion.
Use the front legs as support to raise the unit.
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key
cover.
4
115
CLP-175