Switch Port Commands - ATEN CS1922M User Manual

CS1922M / CS1924M RS-232 Commands
Switch Port
The Switch Port command allows you to switch ports. The default port is 01.
Use the Formula - to set Parameters - to create a Command.
Formula:
Command + Control + [Enter]
Parameters:

Switch Port Commands

Some available formulas for the Switch Port commands are as follows:
1. Command + Control + [Enter]
For example, to switch to port 2, type the following:
sw i02 [Enter]
Note: The Control command can be skipped and the default value will be
used.
8
Command
sw Switch Port Command
Control
ixx Input Port Number
x= 01~04 (Default: 01)
Example: i02
Enter
Enter Enter and send out command
Description
Description
Description