Yamaha CDR-HD1500 Owner's Manual page 79

• Checking the firmwareversion
(Firm. Version)
Soflware that is called "firmware" is built inlo this unit. This
firmware controls Ihe operation. The following steps describe Ihe
firmware version check procedures.
1. Press MENU while this unit is in the stop mode.
The display changes R)r the menu item selection.
2.
Rotate the MULTI JOG knob (press +/-, • or • on the
remote control) to select "Sys. Utility".
_::::' _"' =,,,i = = = ' '= ' =
= = ,=, ,= = ,= ,=, = =
.., = = =, = = = =, ...1
3, Press the MULTI JOG knob (ENTER on the remote
control) to display "Firm. Version".
h..1 h,.. =.,,, = = ,.... h,.. ,....= ,,.,, h,.,
i .L i i'I =: "." =::7 i .:::' .i, :.,.: i i
4.
Press the MULTI JOG knob (ENTER on the remote
control) again to display the version of the firmware.
Rotating the MULTI JOG knob (pressing +/ , • or • on the
remote control) changes the display as follows.
System firmware version
I_i,, 0,,00 .:=i. un 2
!
CDR drive firmware version
,-.r',i::: ............. '.' ." '." i...,
=..,, L.," F., VJ = - =" =
!
Model of HDD
l= h,,'l lib. h. I.,h,,I I = I,' I Ill
i"I i,,,= =,,,, i,,,' i,,,, i =,,,I i I ,i, ,,,= i'., i,,,, i i
5. Press D or MENU to exit.
The unit returns Io the stop mode.
• Initializingsettings(Initialize)
You can initialize the settings that have been changed. The OPC
data stored in this unit is also initialized.
1 • Carry out steps 1 to 3 in "Checking the firmware
version (Firm. Version)" (at left).
The display changes lor the system utility item selection.
2.
Rotate the MULTI dOG knob (press +/-, • or • on the
remote control) to select "Initialize".
= =,,,, ,= ,=, ,= ,,,, = ,= ,,,=, ,,,,
.i, i I .L =.,, .i, ,::a .i, .i, ,=:,, =::7
3, Press the MULTI JOG knob (ENTER on the remote
control) to display "Initialize ?".
= =,,,, ,= ,=, ,= ,,,, = ,= ,,,=, ,,,,,
.i, i I .i, =.,, .L ,:::i .i, ,L ,=:,, =::7
Press D 1o cancel the initialization process.
4.
Press COMPLETE.
The unit restarts with the initial settings.
o
.1-
m
.-i1
rn
c
m
0_