Primos 65064M User Manual page 5

Setting Time and Date (Fig.5)
After the initial Setup screen, the next few display screens will allow you to set the current time and date,
so the time / date stamp imprinted on all your photos and videos will be accurate when captured by the
camera. To change the Time and Date to be current, starting at the default "12:00" screen:
1. Press OK and use UP/DOWN to set the hour (24 hr/military time format). Press OK to confirm.
2. Use UP/DOWN to set the minute. Press OK to confirm.
3. Use UP/DOWN to set the month. Press OK to confirm.
4. Use UP/DOWN to set the date. Press OK to confirm.
5. Use UP/DOWN to set the year. Press OK to confirm and move on to the next Setup item,
Camera ID#.
Setting Capture Mode (1 photo, 3 photos, or video) (Fig.6)
Use UP/DOWN to select your preferred image capture mode: Single Photo per trigger (display shows 1
+ a camera icon), Rapid Sequence of 3 Photos per trigger (display shows a still camera icon + 3) or
Video Clips that are 10 seconds long at 720p resolution (display shows a movie camera icon). Press OK
after setting.
Setting Camera ID# (if using multiple cameras) (Fig.7)
Use UP/DOWN to select a reference ID# (from "01" to "99") for this camera, which will be imprinted on all
photos/videos along with the time & date. If you are only using a single camera to monitor an area, simply
leave it set to the default "Id:01". Set a second camera that will be used in a group of multiple cameras to
"02", etc. Press OK after setting.
SD Card Format (delete all files) (Fig.8)
This display will show "FOrN". CAUTION: be sure to backup and save any/all files you want to keep first,
as formatting will clear the card completely of all files-they will then be difficult or impossible to recover
from the card.
If you are sure you want to format a previously used card, use UP/DOWN to change the "N" after "FOr_"
to "Y" (Yes), then press OK to confirm and delete all files from the card.
Restore Default Setting (initialize camera setup) (Fig.9)
The display will show "dEFN". To return the Camera ID# to their original, "factory default" settings, use
UP/DOWN to change the "N" after "dEF_" to "Y" (Yes), then press OK to confirm. Note: your time and date
settings will not be changed from the current settings to the original defaults, and your SD card will not be
formatted. Only the Camera ID# will be restored to their defaults.