Preparation - Panasonic Nanoe EH‑SA43 Manual

What is nanoe™?
(nanoe™ generation method: High‑voltage discharge)
nanoe™ is charged fine water particles, generated by
applying high voltage in order to split water. It cannot
be seen with the naked eye. Since nanoe™ is
generated by collecting water in the air, it may be
difficult to generate in certain cases depending on the
environment.
(It is harder to collect water in the air when it is cold
and humidity is low.)
Small amounts of ozone are produced.
• Small amounts of ozone are produced while
generating nanoe™. However, the amount of ozone is
similar to the amount naturally existing in a forest,
etc., which does not affect the human body.
• nanoe™ is not visible to the naked eye.

Preparation

1
1
Place the main unit on
a flat, level surface.
• Place the appliance on a
flat, level and solid surface,
such as a desk, etc., when
using. Do not hold the
appliance in your hands
during use. It may not
operate when placed on
certain mats and carpets.
EH-SA43_CH.indb 27
2
2
Remove the water supply
tank from the main unit.
• Pull up on the water supply tank.
3
3
Turn and open the
water supply cap.
4
4
Fill the water supply
tank with water up
to "满水位"(FULL)
and close the water
supply cap.
5
5
Wipe away any water
on the surface of the
water supply tank.
• Do not supply water directly to the main unit.
• No water remains after each use, so add water
every time you use the appliance.
6
6
Attach the water supply
tank to the main unit.
Push the water supply tank
into the main unit until it clicks.
Water is supplied to the main unit
and the water in the tank
decreases when the water supply
tank is attached the main unit.
• Water may leak from the water outlet when the water
supply tank is repeatedly attached and removed.
Full mark
27
2013/04/04 16:03:39