Advertisement
6026 Series Quick Setup Guide
Ethernet Comms Setup
Note: IP address must match database configuration.
Change IP details from default values before connecting to a real network:
1. Using a PC configured to be on the same subnet as the panel default address, connect to the
panel.
2.
Open a web browser, type the default IP address 192.168.1.1 and press Return.
3. In the Control Panel Setup screen that displays in the browser, type the new control panel IP address,
subnet mask, and gateway.
4. Type the Nucleus controller IP addresses and port numbers. Controller port numbers must be greater
than 1024 (excluding 3000).
5. Click Submit Settings.
6. Click Reset Control Panel.
Key Brightness
Hex switch 2 sets the brightness of the keys.
0 = minimum brightness, through to
7 = maximum brightness
(Switch settings 8 - F are not used)
5
Advertisement
