International Harvester Company 15D-2 Operator's Manual page 16

1~~
1~
INSTALLATION
lIIust. 12
l1ydraulic hose connections
. (Models 15D.2 and 15G·2only).
Legend
1.
"0"
RING (1-5/16 x 1-9/16 x liB inch).
2. CLAMP - half.
3. FITTING.
4. HOSE, bulkhead to cylinder (upper).
5. HOSE, bulkhe ad to 'cyl inde r (lower).
6. FITTING.
Installing hydraulic cylinders (Models
150·2
and
15G.2
only)
1. Remove the hoist cylinde r yoke cap
and cap bushing from the hoist cylinder yoke.
Coat the gimbal trunnion hub of the hydraulic
cylinder and the inside and the outside of the
cap bushing with a chassis lubricant. Place
the bushing over the gimbal trunnion hub and
hoist the hydraulic cylinde·r into place.
2. Place the hydraulic cylinders in the
hoist cylinder yokes with the cylinder manifold
next to the engine hood and the manifold holes
facing forward. [Il.lus
t ,
11.)
3. Place the hoist cylinder yoke caps in
position (refer to the following "NOTE") and
secure with 5/8 inch cap screws and lock
washers.
7. TUBE,
"0"
ring seat.
B. HOSE, pump to bulkhead (Lower RH).
9. HOSE, pump to bulkhead
(Upper LH & RH).
10. HOSE, pump to bulkhead (Lower LH).
11. FITTING.
12.
"0"
ring.
NOTE: The hoist cylinder yoke and cap
are a matched set. and have matched numbers
stamped on thern, Be su r e when replacing the
cap on the yoke that the numbers are matched.
Hydraulic hoses (Models
150.2)
and
15G.2
only)
(lIlust.
12)
There are four hydraulic hoses (8, 9 and
10) that connect between the hydraulic pump
and the left and right bulkhead of the radiator
guard. Both upper hoses (9) are 23-1/2 inches
long including fittings. The lower LH hose (10)
is 21 inches long including fittings and the lower
RH hose (B) is 20-1/B inches long including fit-
tings.
Continued on next page.
14