International Harvester Company 15D-2 Operator's Manual page 14

INSTALLATION
lIIust •.9
Connecting linkage and controls (Models
150·2, 15G.2, 150·1
and
15G.l
only),
1. GRIP, hand control adjustable.
Z. GRIP, hand.
3. HANDLE, control.
4. COLLAR, rear control shaft.
4a. WASHER, flat.
5. OIL SEAL, front and rear control shaft.
6. BEARING, needle.
7. BRACKET, rear control shaft.
B. FITTING, lubrication.
9.
RACE, inner.
10. SH.A:FT, rear control.
11. LEVER, front control (inner).
Lla, BOLT, control lever locking.
i
z.
SHAFT, front control.
NOTE:
The race (9) comes assembled
to
the rear control shaft (10).
4. Install the washer (4a) then the collar
(4) over the top of the shaft (10). Align the hole
in the collar with the hole in the shaft and se-
cure with a 5/16 inch cap screw, lock washer
and nut.
5. Install the control handle (3) onto the
shaft (10) and secure with two 1/2 inch cap
screws and lock washers.
6. Insert the handle and grip (1) into the
control handle (3) and secure with a l/Z inch
cap screw and lock washer.
Legend
lZa. FITTING, lubrication.
13. FITTING, lubrication.
14. BEARING, end.
15. ROD, side reach.
16. FITTING, lubrication.
17. LINK, control.
lB. FITTING, lubrication.
19.
LEVER, valve control (Models l5D- Z
and l5G-Z only).
ZO. GUARD, reach rod (Models l5D-l and
15 G-l only).
zr ,
GUARD, reach rod (Models l5D-Z and
l5G-Z only).
7. Connect the reach rod (15) to the lever
of the control shaft (10) and secure with a 1/ Z
inch cap screw and jam nut.
SEAT SIDE SHEET
SEAT SUPPORT- FRONT
IPA-60357
lIIult. 10
Control bracket installation diagram
(Models
150·1, 150.2, 15G·1
and
15G-2
only).
lZ