INSl ALLA liON
lIIu".7
Hydraulic radiator guord and components
(Models
15D·2
and
15G.2
only).
Legend
1.
BUSHING, yoke (outer).
2.
BUSHING, yoke (inner).
3.
FITTING, lubrication
(outer bushing).
4.
FITTING, lub rication (iimer bushing).
5.
GIMBAL, crosstube.
6.
FRAME, mounting.
7.
PLUG, oil filler.
8.
RING, sealing.
9.
PIN, door hinge.
10. EMBLEM.
11. RING, sealing.
12. STRAINER, oil.
13. RING, sealing.
14. PLAT E , strainer
retainer.
15. DOOR, upper.
16. DOOR, lower.
17. GASKET, pump adapter.
18. ADAPT ER, pump.
19. PLUG, magnetic drain.
20. RETAINER, mounting.
21. DOWEL, mounting.
22. GUARD, radiator.
23. DOWEL, mounting.
24. RETAINER, mounting.
4.
Mount the adapter
(18) over the gas-
ket (17).
Align the holes in the adapter
and
gasket with the tapped holes in the bottom tank
of the radiator
guard and secure with four 1/2
inch cap screws.
6.
Slide the yoke fitting (7), (lllust.
3),
onto the splined shaft projecting
from the rear
of the pump.
5.
Fasten a rope around the hydraulic
pump and valve.
Using an overhead hoist,
set
the pump and valve onto the hydraulic
pump
adapter
(18).
7.
Line up the holes in the hydraulic
pump base with the holes in the adapter
(18),
taking care not to disturb the
"0"
rings.
8.
Secure the pump to the adapter
(18)
with four 3/4 inch cap screws
and lock washers.
10