Drilling Hole; Select Position Boiling-Water Tap; Drilling Hole For Boiling-Water Tap; Drilling Hole For Fusion Or Flex Tap - Quooker PRO3 Installation Manual

A

Drilling hole

• The tap hole for the Nordic single tap should be 32 mm in diameter.
The Fusion and Flex tap hole should be 35 mm in diameter.
• The Nordic single tap should ideally be positioned at the corner of the sink to
enable use above the sink or the work top.
• It must be possible to move the spout of the Nordic single tap freely up and
down. When the spout is in its lowest position it projects ca. 25 cm below the
work top. Bear this in mind when fitting the inlet combination, sockets and the
like.
• Note! The Flex tap coupling must be able to move freely. When the hose is not
withdrawn it hangs approximately 40 cm below the work surface top. Make
allowances for this when fitting the inlet combination, power sockets and so forth.
1
3
2
Hole
1 Select position
boiling-water tap
Select a suitable position for the
Nordic single tap based on the type
of sink and position of the mixer tap.
2 Drilling hole for
boiling-water tap
Using the correct drill bit, drill a hole
of 32 mm through the work top for
the Nordic single tap.
NOTE: For the Nordic mixer tap
please refer to the separate guide.
In the case of a hole of 35 mm or
larger, use the centring ring provided.
3 Drilling hole for
Fusion or Flex tap
Select a suitable position for the tap.
Using the correct drill bit, drill a hole
of 35 mm through the work top.
In this, take account of the range of
the tap's spout from the centre of the
tap hole.