Interacoustics Callisto AC440 Instructions For Use Manual page 51

D-0101246-M – 2020/05
Callisto™ - Instructions for Use - US
The Graph shows measured REM curves. The X axis shows the frequency
and the Y axis shows the intensity of the test signal.
Gain/Response View allows for toggling between viewing the curve as a
gain or response curve. Note that this option is not active for REIG .
Measurement Type is indicated above the graph together with a right/left
indication. In this example the REIG is displayed for the right ear.
Change the Input Level using the slider on the right hand side.
Scroll Graph Up/Down on the left hand side allows for scrolling the graph
up or down ensuring that the curve is always visible in the middle of the
screen.
Fitting Prescription and related details can be adjusted on the right hand
side of the screen. Select your preferred fitting prescription in the upper
dropdown list.
Choose between Berger, DSL m[i/o], Half Gain, NAL-NL1, NAL-NL2, NAL-
R, NAL-RP, POGO1, POGO2, Third Gain, or 'Custom' if you have edited
your target with the Edit/Insert target feature.
Targets shown will be calculated based on the selected fitting prescription
and the audiogram and can be shown in the REIG and/or REAR targets.
no audiogram has been entered into the audiogram screen, no targets
will be displayed.
Note that fitting prescription settings (such as Age and Client type) will differ
depending on what fitting prescription is selected.
Measurement Details of the selected curve are displayed as a table on the
right hand side of the screen.
A Curve Comment for each curve can be typed into the comment section
on the right hand side.
Select a curve using the curve tag boxes under Curve display options and
write a comment in the comment section.
The comment will then appear in the comment section whenever the curve
is selected.
Curve Display Options are found in the lower right hand corner.
If you have measured more curves of the same type (e.g. REIG curves),
they will be listed by their input level. Tick the ones that are to be displayed
on the graph.
Right clicking on the input level in the curve display will give the fitter
various options
If
Page 47