Getting Started; Inserting Batteries Into The Remote Control; Using The Remote Control; Turning On The Power - Yamaha DVD-S557 Owner's Manual

Step1: Inserting batteries
into the Remote Control
3
1
2 2
1 Open the battery compartment.
2 Insert the supplied two batteries type R06
or AA, following the indications (+ –)
inside the compartment.
3 Close the cover.

Using the remote control

Point the remote control
at the sensor, within
approximately 6 m
(20 feet) of the unit.
Handling the remote control
• Do not spill water or other liquids on
the remote control.
• Do not drop the remote control.
• Do not leave or store the remote
control in the following types of
conditions:
– high humidity such as near a bath
– high temperature such as near a heater
or stove
– extremely low temperature
– dusty places
1 Connect the AC power cord to the power
2 Turn on the TV and your AV receiver.
3 Select the appropriate input source at the
4 Turn this unit on.
5 Set the TV to the correct Video IN channel
Remote control
sensor
1 Press SETUP.
2 Press 2 repeatedly to select [VIDEO
3 Press 34 to highlight [TV TYPE], then

Getting Started

Step2: Turning on the power
outlet.
AV receiver that was used to connect to
this unit. Refer to the equipment owner's
manual for details.
(eg. EXT1, EXT2, AV1, AV2, AUDIO/
VIDEO, etc. Refer to your TV owner's
manual for details).
The front display lights up and the
default screen appears on the TV.
Step3: Selecting the color
system that corresponds to
your TV
This DVD Player is compatible with both
NTSC and PAL. Select the color system
that matches your TV.
VIDEO SETUP PAGE
TV TYPE PAL
TV DISPLAY NTSC
PROGRESSIVE MULTI
PICTURE SETTING
COMPONENT
SETUP PAGE].
press 2.
7