Table of Contents
Advertisement
Preparation Procedure
Step 3: Installing this unit in the conference room
After completing the settings, follow the procedure below to install this unit in the place of conference, such as a
conference room.
■ About installation environment
The speakers of this unit are attached in the downward orientation on the bottom panel. Place this unit horizontally on a
desktop without placing any object below this unit. In case you cannot place the unit stably because of the shape of the
desk or other reasons, attach the supplied pads (3 pieces) as illustrated.
Back panel of this unit
1 pad
Attach 1 pad at the center so
that the concave part is
covered.
Concave part
Pad
■ Take the positions of the talkers in consideration
To assure the clear conversation by making the most of the effect of arrayed microphones and speakers, place this unit so
that the talkers sit at the area highlighted on the following figure.
Side of
this unit
Note
The microphones cannot pick up the audio clearly when the talker sits in one of the positions marked "
y
Depending on the using environment, you can configure the setting of the audio pickup area. Refer to "Selecting the audio pickup area
(microphone mode)" (page 28) for details.
14
Display side
Attach 2 pads at the corner so that
the rubber cushions are covered.
Front of this unit
1
2
3
4
5
6
7
8
9
0
MIC MUTE
VOL
Front of this unit
2 pads
Rubber cushion
Pad
Side of
this unit
" in the figure above.
Advertisement
Table of Contents
