Table of Contents
Advertisement
■ Assigning the IP address manually
Follow the procedure below to register the network
information manually.
Note
Before setting the network information, check that this unit is
connected properly to the network. If the disconnected icon
(page 10) is displayed on the top right of the display, check the
LAN cable connection and the condition of the network to which
the LAN cable is connected.
y
The factory settings of the network information are as follows.
– IP address: 192.168.100.200
– Subnet mask: 255.255.255.0
– Default gateway: 0.0.0.0
/
1
Press
repeatedly until the initial display
appears.
"???.???.???.???" is displayed when the DHCP server
does not exist in the network, and the IP address
obtained from the DHCP server is displayed when it
exists.
IP: ???.???.???.???
Menu :Address
2
3
Numeric keys
1
2
3
4
5
6
7
8
9
0
MIC MUTE
VOL
/
4
Press
.
The menu screen appears.
Menu
1. Settings
2. Call History
3. Online
Press
or
to select "1. Settings", and
then press
.
The "Settings" menu appears.
Settings
1. Network Settings
2. Sound Settings
3. General Settings
Press
or
to select "1. Network Settings",
and then press
.
The "Network Settings" menu appears.
Network Settings
1. IP Address
2. Subnet Mask
3. Default Gateway
Preparation Procedure
11
Advertisement
Table of Contents
