SETTINGS CONFIGURATION AND MANAGEMENT
Name
Reboot Device
Webapp debug
Daisy Chain
Factory Reset
Time
Enable NTP
Description
To reboot the phone when needed.
You can use this function only through the web
interface.
To enable or disable the debugging function for the web
application. It activates the web application logging available
in the
System Logs
You can use this function only through the web
interface.
To choose a mode, in which your Konftel 800 operates in
case of a daisy chain arrangement. The options are:
•
. This is the default setting.
Master
•
Slave
You can configure this parameter if you logged in with
the administrator password.
To reset the phone to its factory settings. By resetting the
phone to its factory settings, you remove all the
configurations set, imported and installed in course of the
phone use.
You can do the factory reset only if you log in with the
administrator password and only on the phone.
To enable or disable the Network Time Protocol (NTP). By
default, NTP is enabled.
You can configure this parameter if you logged in with
the administrator password.
tab. By default,
Webapp Debug
31
is off.
Table continued...