Recording A Compact Disc - Yamaha CC-50 Owner's Manual

RECORDING A COMPACT DISC

Receiver
CD Player
Tape Deck
4
TUNER DIRECT
1 2
1 2
6 7
6 7
A B
TIME PROG
REPEAT
DOWN
5
RANDOM PLAY
DECK
A/B
EFFECT LEVEL
- +
POWER SLEEP
1
6
5 3 2
3 4 5
3 4 5 6
8
8 9 0
C D E
+
TAPE EDIT I0
STOP PLAY/PAUSE CD
PRESET A/B/C/D/E TUNER
UP
1
STOP PLAY TAPE
REC/PAUSE PHONO/AUX
DSP MODE SP/PHONES
DISPLAY VOLUME
- +
•
When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
•
Adjusting the VOLUME, BALANCE, TREBLE and BASS
controls have no effect on the recorded sound.
If, however, the DSP is on, the DSP effect is recorded
along with the source.
* Music with DSP effect is suitable for listening to inside
a car etc.
•
For the tape deck, the deck which can be used for
recording is the DECK B only. When recording, be sure to
load a tape into the DECK B cassette compartment.
CD synchronized recording
1
Select the CD player so that "CD" appears on the display
by pressing the INPUT selector
the disc to be recorded.
2
Load a tape into the DECK B cassette compartment.
* Wind past the beginning part of the tape on which
recording can not be performed.
3
When recording with the Dolby NR system, set the Dolby
NR switch to B or C; if not, set it to OFF.
* For selection of the Dolby B or C position, refer to the
"Dolby B and C Type Noise Reduction" on page 29.
4
Set the reverse mode switch as desired.
When the tape is set so that side A faces you, recording will
be done as follows automatically according to the selected
reverse mode.
Side A only
Side B only
5
Press the REC/PAUSE button.
* The corresponding indicator will light up and the play
direction indicators flash.
6
Start CD playback by pressing the play/pause button.
* Before CD playback begins, recording automatically
begins on the side of the tape now selected.
E-30
or button, and load
Side A Side Side A Side
B B
Side B only Side B only