Automatic Operation - Brief Instructions - BÖWE M21 Instruction Manual

6. Operation

6.2 Automatic Operation - Brief Instructions

Open valves for water, steam, condensate, compressed air.
Set up the power supply
Before starting, make sure that all doors and covers are closed.
Turn main switch "ON"
Display: The display shows which software
relating to the solvant has been installed. Delete with "C"
"Textile Cleaning"
Machine type, for example:
Then the deodorizing program "P43" is displayed.
Press the "Start " button.
After the signal sounds, press the "Stop" button.
Loading:
Open the loading door, load the cage according to the filling capacity,
close the loading door.
Erase the displayed, previous program
P43 by pressing "C".
Select a program according to the overview.
Input the required program
(program and number)
Start:
Press "Start". The pointer E114 might appear. Delete with "C".
The program executes automatically.
During automatic and manual operation, the loading door is locked from
the start of the cycle until the end (signal).
If there is a failure or if the door limit switch is not adjusted correctly,
there will be an alarm indication.
A signal that sounds in intervals announces that the program has ended.
Stop: Press the "Stop" button*.
Open the loading door and unload the garments.
Close the loading door.
If you repeat the same program, you only need to load the garments,
close the loading door and press the "Start" button.
If you do not restart the machine, the
loading door locks. You can unlock the door with the
"" button for up to 10 minutes. Starting with the 11
Turn off the main switch if there is a risk of any kind.
If the machine is severely out of balance during spinning, stop it by
pressing the "STOP" button",or by pressing pushbutton
reduce the number of revolutions.
Caution
* When pressure in the machine has built up (visible as a block diagram in the display) the signal
E106 appears. When the pressure has dissipated, the loading door unlocks and can be opened.
26
"BOEWE"
"M21"
th
minute, start "P43" deodorizing.
6.
6.2
START
STOP
C
2
PROG
START
STOP
M21-M26-M30