XiNCOM Twin WAN XC-DPG402 User Manual page 53

Protocol &
Protocol and Port Binding
Port Bind ing
Use
particular W
•
•
•
•
•
•
•
U sing Remote W b-based Setup e
To connect to the XC-
1. Ensure that both y
2 . Start yo ur Web r B owser.
3 . In the "A ddress" b
WAN Route r. If the port
enter ":" follow ed y the port number.) b
e.g .
HTTP ://123 .123.123.123:8080
•
This examp le assumes the W
8080.
•
If using the Dy
e.g.
HTT P://my _domain_name.dyndns.org:8080
these settings if you wish to ensure that particular traffic is sent by a
AN port, and thereby a particular IS
Enable - Enable or disable each item as required.
Source IP - IP address of source w
Destination IP – IP address of destination which packets are sent to.
Subnet Ma sk – With subnet mask other than 255.255.255.255, you can
make a IP sub-network as your destination.
Protocol - Select the p
Port Range - Enter the beginning and end of the port range
you wish to configure. If only a single port is used, enter the port number in
bot h fields.
WAN - Select the port you wish this traffic to use.
DPG Twin WAN Router from a remote PC via the Internet:
our PC and the XC-DPG Twin WAN Rout
ar, enter "HTTP://" followed by the Internet IP Address of the XC-DPG Twin
number is not 80, the port number is also required. (After the IP Address,
AN IP Address is 123.123.123.123, and the port number is
namic DNS f eature, you can connect using the domain name allocated to you.
P account.
hich packets are sent from.
rotocol used by the traffic you wish to configure.
er are connected to the Internet.
XiNCOM Corp.
used by the traffic
Page 51