XiNCOM Twin WAN XC-DPG402 User Manual page 16

2. Installing the XC-DPG Twin WAN Router in your LAN
1. Ensure the XC-DPG Twin WAN Router and the DSL/Cable modem are powered OFF.
Leave the modem or modems connected to their data line.
2. Connect the Broadband modem or modems to the XC-DPG Twin WAN Router.
•
If using only one (1) Broadband modem, connect it to the "WAN 1" port.
•
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
3. Use standard LAN cables to connect PCs to the Switching Hub ports on the XC-DPG Twin WAN
Router.
•
Both 10BaseT and 100BaseT connections can be used simultaneously.
•
If you need to connect the XC-DPG Twin WAN Router to another Hub, just use a standard
LAN cable to connect any port on the XC-DPG Twin WAN Router to a standard port on
another hub. Any LAN port on the XC-DPG Twin WAN Router will automatically act as an
"Uplink" port when required.
4. Power Up
•
Power on the Cable or DSL modem or modems.
•
Connect the supplied power adapter to the XC-DPG Twin WAN Router and power up.
5. Check the LEDs
•
The Power LED should be ON.
•
The WAN – Link LED should be ON, if the corresponding WAN port is connected to a
broadband modem.
Page 14
Figure 7: Installation Diagram