Configuring Other Routers On Your Lan - XiNCOM Twin WAN XC-DPG402 User Manual

Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries.
You can not modify or delete these entries.
Settings – Stat ic Routing
•
Entry Index
•
•
Network The network address of the remote LAN segment. For standard class "C" LANs,
Address the network address is the first 3 fields of the Destination IP Address. The 4th
(last) field can be left at 0.
Net mask The Network Mask for the remote LAN segment. For class "C" networks, the
default mask is 255.255.255.0
The IP Address of the Gateway or Router which the XC
Gateway
must use to communicate with the destination above. (
the remote segment.)
Interface Select the correct interface, usually "LAN". The "WAN" interface is only available
if NAT (Network Address Translation) is disabled.
Metric The number of "hops" (routers) to pass through to reach the remote LAN
segment. The shortest path will be used.

Configuring Other Routers on your LAN

All traffic for devices not on the local LAN must be forwarded to the XC-DPG Twin WAN Router, so
that they can be forwarded to the Internet. This is done by configuring other Routers to use the XC-
DPG Twin WAN Router as the Default Route or Default Gateway, as illustrated by the example
below.
Page 58
If adding a new entry, ignore this field.
To edit an e xisting entry, select it from the list, and click the "Select" button.
The screen will th en update with the data for the selected entry.
If the Index is 0, th is is a System entry which you can neither delete nor
modify.
-DPG Twin WAN Router
NOT the router attached to