•
The Error LED will flash during start up, but will then turn Off. If it stays On, there is an error
condition.
•
For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100)
should be ON.
3. Configuring the XC-DPG Twin WAN Router for Internet Access
Select Primary Setup from the menu, to see a screen like the example below.
•
Configure WAN 1 and/or WAN 2 as required.
•
For any of the following situations, refer to Chapter 3: Advanced Port Setup for any further
configuration which may be required.
•
Using both ports
•
Multiple IP addresses on either port
•
Multiple PPPoE sessions
•
PPTP connection method
Figure 8: Primary Setup Screen
XiNCOM Corp.
Page 15