Mitsubishi Electric 800 Series Instruction Manual page 30

2.
Outputting separate signals from terminals AM0 and AM1 (Pr.309 = "1 or 11")
START
Connect a DC voltmeter (or DC ammeter)
across terminals AM0 (or terminal AM1) and AMC.
Use Pr.323 (or Pr.324) to calibrate the meter
when the voltage (current) input is 0.
Set "21" (reference voltage output) in Pr.306
and Pr.310.
Terminal AM0
Use C0 (Pr.900) to set
END *1
*1 In Pr.306 and Pr.310, set the types of the signals to be output. (Refer to
NOTE
• If calibration is performed without setting "21 (reference voltage output)" in Pr.306 or Pr.310, the terminal FM or AM of the
inverter is calibrated. To calibrate the extended analog output, always set to "21".
• When the plug-in option used was remounted on another inverter, use Pr.323 and Pr.324 to calibrate again.
30
ANALOG OUTPUT
At this time, check that the polarity is correct
If the meter needle does not point to 0 when voltage or current input is 0,
use Pr.323 AM0 for 0 V adjustment or Pr.324 AM1 for 0 mA adjustment of
the meter
At this time, the following analog signal is actually output and deflects the meter.
<across terminals AM0-AMC>
Maximum output voltage set previously (factory setting: 10 VDC)
<across terminals AM1-AMC>
Maximum output current set previously (factory setting: 20 mADC)
Terminal AM1
Use C1 (Pr.901) to set
Make adjustment with the setting dial or the UP/DOWN key to deflect
the meter needle to full-scale, then press the SET key to set.
page 31.)