Figure 10: Drilling Template - WAGO 852-111 Manual

20 Assembly

Figure 10: Drilling template

The setup of the Industrial Switch can be performed using the following steps:
• The surface must support at least 1.5 kg for the Industrial Eco Switch.
• Visually inspect the DC power jack and make sure that it is fully secured to
the power adapter.
• Make sure that there is proper heat dissipation from and adequate ventilation
around the Industrial Switch. Do not place heavy objects on the Industrial
Switch.
• The carrier rail must optimally support the EMC measures integrated into
the system and the shielding of the internal data bus connections.
Important note
Grounding Industrial Eco Switch will help eliminate the effects of noise due to
electromagnetic interference (EMI). Always run the ground connection from the
ground screw to the grounding surface prior to connecting DC power.
Pos: 8.4 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Geräte anschließen - Überschrift 2 @ 3\mod_1234172889468_21.doc @ 27460
852-111 5 Port 100BASE-TX Industrial Eco Switch
Note
WAGO-ETHERNET-Accessories 852
Manual
Version 1.0.0