General; Package Contents; Industrial Ethernet Technology; Switching Technology - WAGO 852-111 Manual

WAGO-ETHERNET-Accessories 852
852-111 5 Port 100BASE-TX Industrial Eco Switch
Pos: 4.1 /Serie 852 (Ethernet-Zubehör)/Einleitung/Einleitung @ 3\mod_1222676076609_21.doc @ 22308
2

General

Pos: 4.2 /Serie 852 (Ethernet-Zubehör)/Einleitung/Paketinhalt 852-111, 112 @ 4\mod_1236945288734_21.doc @ 28399
2.1

Package Contents

• 1 Industrial Eco Switch
• Carrier rail support
Pos: 4.3 /Serie 852 (Ethernet-Zubehör)/Einleitung/Industrielle Ethernet Technologie 852-111, 112 @ 4\mod_1236945644828_21.doc @ 28403
2.2

Industrial Ethernet Technology

The line of switches from WAGO ensure the scalability of your network
infrastructure with outstanding electrical and mechanical characteristics. These
robust devices are designed for industrial use and they are fully compliant with
IEEE802.3, 802.3u.
They have voltage supply with a supply voltage range of 18 ... 30 V.
Characteristics such as auto negotiation and auto MDI/MDIX (crossover) on all
10/100 BaseTX ports are realized.
Pos: 4.4 /Serie 852 (Ethernet-Zubehör)/Einleitung/Switch Technologie @ 3\mod_1222683606296_21.doc @ 22317
2.3

Switching Technology

Another approach to pushing beyond the limits of Ethernet technology is the
development of switching technology. A switch bridge Ethernet packets at the
MAC address level of the Ethernet protocol transmitting among connected
Ethernet or Fast Ethernet LAN segments.
Switching is a cost-effective way of increasing the total network capacity
available to users on a local area network. A switch increases capacity and
decreases network loading by dividing a local area network into different
segments, which don't compete with each other for network transmission
capacity.
Pos: 4.5 /Serie 852 (Ethernet-Zubehör)/Einleitung/Auto Negotiation @ 3\mod_1222427670250_21.doc @ 22290
2.4

Auto Negotiation

The Industrial Switch's 10/100Mbps switched RJ-45 ports auto negotiates with
connected devices to determine the fastest data transmission rate supported by
both devices. This helps make the Switch a plug and play device. The Switch's
RJ-45 ports support full or half duplex, depending on which transmission speed is
supported by the attached device.
Pos: 4.6 /Serie 852 (Ethernet-Zubehör)/Einleitung/Switching, Filtern @ 3\mod_1222427760578_21.doc @ 22298
2.5

Switching, Filtering

Packets entering the Industrial Switch with source and destination addresses
belonging to the same port segment will be filtered, limiting those packets to one
port, and relieving the rest of the network from the need to process them. A packet
with a destination address served by another port segment will be forwarded to the
appropriate port, and will not be sent to the other ports where it is not needed.
Packets that are used to maintain network operations (such as the occasional multi
cast packet) are forwarded to all ports.
Manual
Version 1.0.0
General 11