Trouble Shooting; Repairs; Safety Procedures - probst KKV 8/14 Operating Instructions Manual

Operating Instructions
KKV 8/14
8.3

Trouble shooting

ERROR
The clamping-power is not big enough,
the load is slipping out
(optional)
(optional)
(Adjustment of the gripping range)
(optional)
(Property of material)
Unbalanced load
(Adjustment of the gripping range)
(optional)
Automatic release does not work
mechanical
(optional)

8.4 Repairs

●
Only persons with the appropriate knowledge and ability are allowed to repair the device.
●
Before the device is used again, it has to be checked by an expert.
8.5

Safety procedures


It is the contractors responsibility to ensure that the device is checked by an expert in periods of max. 1
year and all recognized errors are removed ( see BGR 500).

The corresponding legal regulations and the regulations of the declaration of conformity have to be
observed!

We recommend, that after checking the device the badge „Safety checked" is put on the device.
(Order-No.: 2904.0056+inspection sticker with date).
●
You can receive these badges from us.
14 / 15
Maintenance and care
CAUSE

The grippers are worn

The maximum load is exceed

The actual opening width is not
correct

The surface of the material is dirty
or the material is not suitable /
allowed for this device.

The device is not loaded
symmetrically

The adjustment of the gripping
range is not symmetrical.

Automatic release does not work
V1
REPAIR

Replace the grippers

Reduce the weight of. the load

Adjust the gripping range
according to the load you want to
transport

Check the surface of the material
or ask the manufacturer, if you the
material is allowed for this device.

Adjust the position of the load

Correct the adjustment of the
gripping range

Clean automatic release with high
pressure-cleaner

Oil the automatic release (never
with grease)

Change the inset of the automatic
release
GB