Set Up And Installation - TECHCON SYSTEMS TS1251 User Manual

4.0 SET UP AND INSTALLATION

1. Remove pressure dispenser from shipping container and inspect for damage. Refer to Users Manual Section 7.0
for Warranty Data. Install pre-assembled Regulator (8) on Rear Base.
CAUTION: Plant air supply should provide dried, filtered air with pressure not to exceed 100 psi. If plant air is
not dry and filtered, a Techcon Systems 5 Micron Air Filter (TSD800-6) is available as a recommended
accessory.
2. Insure Pressure Regulator (8) is off (set at zero), turn Regulator Knob clockwise until it stops.
3. Attach Air Hose from filtered source (see Caution above) to Male Quick Connect Air Inlet Fitting (5) on Regulator
at Base of Dispenser.
4. Connect Dispense tube (10) onto Barbed end of Luer Fitting (11) on top side of Dispenser. (Refer to figure 1).
Insure Tube (10) is covering fitting.
CAUTION: Never pour Adhesives or other materials directly into Dispenser. Use Adhesive Bottle or similar
containment vessel.
5. Remove Cap and Dip Tube supplied with new Adhesive Bottle. Discard Tube, Cap may be saved for future
resealing of bottle (See Section 6.0 Cleaning).
6. Using Dip Tube (12) supplied with dispenser, insert Tube into Bottle and place Bottle into Reservoir of Dispenser,
attach Luer Lock fitting (Refer to Fig. 1). When tightening Luer Fitting (12), support Tube to allow for twisting to be
absorbed in fingers and not allow Tube to flail out of Bottle.
7. Close Lid, swing Knob Assembly (7) up to vertical position and hand tighten Knob firmly.
NOTE: Dispense Tube must be attached to dispensing option (i.e. Pen or Micro Shot Valve) before pressure is
applied to Dispenser.
FIGURE 1
DISPENSE TUBE ASSY..
Page 6