Table of Contents
Advertisement
2.0 INTRODUCTION
The TS1251 PRESSURE DISPENSER offers a convenient, easy to use system for dispensing *cyanoacrylates,
as well as many solvents, lubricants and other low viscosity materials. Loosen Clamp Knob, swing Lid open,
place a container of material to be dispensed, connect Dip Tube, close lid, tighten Clamp Knob, pressurize
chamber and begin dispensing. The simplicity and reliability of the TS1251 PRESSURE DISPENSER'S design
provides for exceptional performance, minimum maintenance, and easy repair.
SPECIFICATION:
SIZE:
WEIGHT:
MAX OPERATING PRESSURE
FEATURES:
3.0 DESCRIPTION
The TS1251 PRESSURE DISPENSER enables dispensing of low viscosity materials directly from one-pound
bottles. Air pressure forces the material from the bottle in the dispensers see through pressure chamber and
through a disposable supply line into an optional TS1201 Dispensing Pen or TS1212 Micro Shot Valve assembly.
The material is dispensed through disposable polyethylene fittings/lines to the Dispensing Needle. The material
flow rate is controlled by an Air Pressure Regulator on the Dispenser Base. The quantity is controlled by the Pinch
Valve in the optional Pen or On-Off Valve assembly.
Warning
* Cyanoacrylate Adhesives are severe eye irritants and skin bonders. Immediate bonding of eyes, skin or
mouth may occur upon contact. These Adhesives may cause permanent eye damage.
Read the material safety data sheets for special precautions for the specific material being dispensed. Wear
Protective safety equipment as specified in the material safety data sheets.
•
No Tubes through Hinged Lid.
•
See through Reservoir for material monitoring (Cast acrylic Reservoir offered as
standard. Glass Reservoir available).
•
One hand opens and closes Fixed Lid.
•
Easy to replace, disposable Dip Tube and Dispense Lines.
•
Optional integrated on-off Valve assembly available.
•
Optional Valve Controller available.
•
Accepts standard one pound cyanoacrylate bottles.
6 X 6 X 10 INCHES
(15.3 X 15.3 X 25.4 cm.)
9 LBS. (4.1 kg)
30 psi. (2 BAR)
Page 4
Advertisement
Table of Contents
