IMPORTANT:Make sure rubber side of the seal plug
(2) faces towards the clutch when installing.
6. Insert seal plug (2) into the housing and race (5) us-
ing a driver.
7. Secure clutch shaft to housing and race (5) with lock
washers (16) and hex socket head screws (17).
8. Lower front wheels to ground.
Workman 4000 Series
9. Make sure drain plug is installed properly to the
transaxle. Fill transaxle with Dexron III ATF (see Chang-
ing Transaxle/Hydraulic Fluid in the Service and Repairs
section of Chapter 6 – Drive Train).
10. Install differential drive shaft (18) to clutch shaft (1)
and the front differential (see Differential Drive Shaft
Installation).
Page 10 – 37
Front Wheel Drive Section – 4WD (Rev. F)