Bleeding Air From the Injectors
This procedure should only be used if the fuel system
has been purged of air. (See Bleeding the Fuel System
in this section of the book.)
1. Loosen the pipe connection at the number one nozzle
and holder assembly on the cylinder head (Fig. 41).
2. Push accelerator pedal to the floor.
3. Turn the ignition key to the START position to crank
the engine and pump fuel to the nozzles. Turn the
ignition key to the OFF position when a steady stream
of fuel flows out of the loose pipe connection.
4. Tighten the pipe connector.
5. Repeat steps 1 - 4 for the No. 2 and No. 3 injector
nozzle and holder.
Fuel Pump Service
The only serviceable parts of the fuel pump are the
magnet, filter, and the gaskets on each end of the filter.
1. Disconnect the fuel pump wires from the wiring har
ness and ground connection.
2. Disconnect the fuel hoses from the pump. Plug the
fuel lines.
3. Remove the two screws which secure the pump to
the frame.
4. Use a 17 mm wrench to remove the cover from the
fuel pump (Fig. 42). Remove the gasket, magnet and
filter element.
Workman 3300-D/4300-D
1. Fuel injector nozzle and holder (3)
1. Cover
2. Cover gasket
3. Magnet
Page 4 - 51
1
Figure 41
Figure 42
4. Filter
5. Body
Liquid Cooled Diesel Engine