Table of Contents
Advertisement
Troubleshooting
Symptom
System does not power up
Reduced Airflow
If the unit does not work after checking the above, please contact PACE, or your Authorized
PACE Distributor if outside U.S.
Filter Replacement & Spare Parts
PACE Fume Extraction Systems are equipped with filters designed to capture particulates and
noxious gases and odors that are present in the air being filtered. Over time, the filters will
become clogged, impeding airflow through the system and the capacity of the gas filter (if fitted)
will be reached, reducing its ability to continue to neutralize and adsorb noxious gases and odors.
Do not attempt to clean any PACE fume extraction filters for reuse. Cleaning the filters will
severely damage the filter media and, consequently, the filter's performance. This will result in
unfiltered, contaminated air being returned to the working environment. Unfiltered air can also
damage the fan assembly.
To ensure the highest level of performance, use only PACE replacement filters in your PACE
Fume Extraction System.
BE SURE the new filter cartridge is installed with the airflow arrow pointing downward.
When disposing of used filters, extreme care must be taken to comply with all applicable
environmental regulations. Carefully consult the MSDS supplied with the material(s) producing
the fume. If in doubt, check with your local Environmental Authority.
PART NUMBER
8889-0050
8883-0125-P5
8883-0280
8883-0290
8883-0295
8883-0300-P5
8886-0055
Possible Cause
No power supplied to unit
Filter blocked, Optional
Arm attachment not installed
correctly
DESCRIPTION
ARM-EVAC 50 (DUAL VOLTAGE)
ARM-EVAC 50 PRE-FILTER PKT 5
ARM-EVAC 50 STANDARD FILTER (85%)
ARM-EVAC 50 CLEAN ROOM FILTER (99%)
ARM-EVAC 50 ADHESIVE FILTER
ARM-EVAC 50 FOAM FILTER PKT 5
ARM-EVAC 50 ARM ADAPTOR & ARMS (2)
8
Solution
Check power cord
Is connected and power
Is switched on.
Check & change filter(s)
if req, check Arm
attachment connection.
Advertisement
Table of Contents
