Table of Contents
Advertisement
Plenum Operation
1.
Remove Arm-Evac 50 from packaging and place on workbench.
2.
Insert filter, ensuring that you follow airflow guide.
3.
Plug power cord (supplied) into receptacle at rear of unit, ensuring that it is connected to
a properly grounded outlet.
4.
The unit is now ready for use.
Optional Arm Extraction Operation
1.
Ensure Arm-Evac 50 is switched off and is disconnected from power outlet.
2.
Lift Arm-Evac unit and slot Plenum opening into locating grooves on Arm Adaptor
3.
Push fit Extraction Arm(s) into outlet(s) on Arm Adaptor. If only one Extraction Arm is
required, use Blanking Plug supplied to block other outlet.
4.
Position Extraction Arm(s) as required.
5.
Follow steps 1, 2 & 3 of Plenum Operation
6.
The unit is now ready for use.
Maintenance
Fuses:
The fuse is located in a sliding tray at the rear of the unit, just below the power
receptacle. Each Arm-Evac is supplied with one replacement fuse, also located
in the sliding tray.
Replacement fuses are available for the Arm-Evac 50 systems in packages of 5 fuses.
5a fuse, part number 8884-9965-P5
Fan Assy:
The Arm-Evac 50 is fitted with a maintenance free, brush-less fan assembly,
which does not require routine maintenance. It is important that fume extractor
filters are changed on a regular basis to protect the fan assembly.
Housing:
The housing of the Arm-Evac 50 is manufactured from a static safe ABS
material, which may require routine cleaning to remove any build up of
particulates and flux fume residue. We recommend the use of a mild, plastic
safe cleaner with a soft cloth to clean the unit, should it be required.
A vent is located at the rear of the unit to allow the cleaned air to return to the
workplace.
assembly.
Never operate the Arm-Evac 50 without filters installed.
Do not cover this vent as this may cause damage to the fan
7
Advertisement
Table of Contents
