Table of Contents
Advertisement
Troubleshooting
Symptom
System will not turn on.
Reduced Airflow
If the unit does not work after checking the above, please contact PACE, or your authorized PACE
distributor.
Filter Replacement & Spare Parts
PACE f ume extraction s ystems are equipped with filters designed to capture particulates and noxious
gases and odors. Over time the filters will become clogged, impeding airflow through the system as
well as reducing the ability of the gas filter (if present) to continue to neutralize and adsorb noxious gases
and odors.
Do not attempt to clean any PACE fume extraction filters for reuse. Cleaning the filters will severely
damage the filter media and negatively efffect the filter's performance. This can result in unfiltered,
contaminated air returning to the working environment or damaging the fan assembly.
To ensure the highest level of performance, use only PACE replacement filters in your PACE Fume
Extraction System.
BE SURE the new filter cartridge is installed with the airflow arrow pointing away from the front
of the unit.
When disposing of used filters, extreme care must be taken to comply with all applicable environmental
regulations. Consult the MSDS supplied with the material(s) producing the fume. If in doubt, check with
your local Environmental Authority.
PART NUMBER
8889-0050-P1
8883-0125-P5
8883-0280-P1
8883-0290-P1
8886-0055-P1
©2013 PACE Inc., Vass, North Carolina. All rights reserved. www.paceworldwide.com
Possible Causes
No power supplied to unit
Filter blocked.
Arm attachment not installed correctly.
ARM-EVAC 50 STANDARD FILTER (85%)
ARM-EVAC 50 CLEAN ROOM FILTER (99%)
ARM-EVAC 50 ARM ADAPTOR & ARMS (2)
Solution
Make sure the power cord is fully seated and
that the power is turned on.
Check & change filter(s)
Make sure all accessories are fully seated.
DESCRIPTION
ARM-EVAC 50 (DUAL VOLTAGE)
ARM-EVAC 50 PRE-FILTER PKT 5
6
Advertisement
Table of Contents
