Kioti DK 802 Manual page 73

5-16 DK802/902
MIXED CONTROL
(1) Ground Surface (2) Soft Soil
(3) Implement Penetration Limit
In the draft control mode; when draft
decreases, the implement automatically
lowers to increase draft. To avoid hav-
ing the implement lowered too far, set
the position control lever at the lowest
working depth desired. Move the draft
control lever to the point where the imple-
ment is at the desired depth. This pre-
vents the implement from going too deep
and causing loss of traction and ground
speed.
3-POINT HITCH LOWERING SPEED
T30O519A
(1) 3-point hitch lowering speed knob
(A) Lock (
The lowering speed of the 3-point hitch
can be controlled by adjusting the 3-point
lowering speed knob.
CAUTION
To avoid personal injury:
Fast lowering speed may cause
damage or injury. Lowering speed
of implement should be adjusted
to two or more seconds.
CONNECTING HYDRAULIC ACCESSORIES
- DOUBLE ACTING VALVE (IF EQUIPPED)
T30O520A
) Fast ( ) Slow
To avoid personal injury:
Stop the engine and relieve pres-
sure before connecting or dis-
connecting lines.
Do not use your hand to check
for leaks.
T30O521A
CAUTION