HOME CONTROL – THERMOSTAT CONTROL
When the "Operator" is on the line, perform the following steps to
change the thermostat control.
separate modes:
Thermostat mode
(NOTE: The "Operator" will only function with a special type of
thermostat, which may not be currently available in your area.
Contact your installer.)
Step 1
Press
ρ
The [ρ] accesses the MENU and [6] takes you to the HOME
CONTROL menu, then [2] proceeds to the THERMOSTAT
CONTROL section.
Step 2
"INSIDE TEMPERATURE IS ZERO."
"OUTSIDE TEMPERATURE IS ZERO."
"THERMOSTAT MODE IS EMERGENCY. TO CHANGE,
ENTER [0]."
"FAN MODE IS AUTO. FOR ON MODE, ENTER [1]."
"DAY MODE IS ON.
ENTER [2]."
"DAY MODE HEAT SET POINT IS ZERO. TO CHANGE,
ENTER [3]."
"NIGHT MODE HEAT SET POINT IS ZERO. TO
CHANGE, ENTER [4]."
"DAY MODE COOL SET POINT IS ZERO. TO
CHANGE, ENTER [5]."
"NIGHT MODE COOL SET POINT IS ZERO. TO
CHANGE ENTER [6]."
Step 3
When you have heard the status of the THERMOSTAT
mode, when you enter a number to change, the
"Operator" will ask you to "PLEASE WAIT."
The thermostat control has three
Fan mode
6
2 .
TO SELECT NIGHT MODE,
Day mode
Need help?
Do you have a question about the NetworX Series and is the answer not in the manual?